How to debug the parameters of high-speed wire cutting control cabinet?

1. Understand the basic parameters of the control cabinet:

Before debugging, you must first understand the basic parameters of the control cabinet, including input voltage, output voltage, current, frequency, etc. These parameters can usually be found in the manual of the control cabinet, or you can directly ask the equipment manufacturer.

2. Check the power connection:

Make sure the power supply of the control cabinet is connected correctly, the power cord is in good contact, and is not loose or damaged. At the same time, check whether the power supply voltage is stable and meets the requirements of the control cabinet.

3. Adjust current and frequency:

According to the requirements of the cutting machine, adjust the output current and frequency of the control cabinet. Usually, the cutting speed and quality of the cutting machine are related to the current and frequency, which need to be adjusted according to the actual situation.

4. Adjust the cutting voltage:

Cutting voltage is an important parameter for controlling the cutting arc length and cutting speed. By adjusting the output voltage of the control cabinet, the length and intensity of the cutting arc can be changed. Generally speaking, the higher the cutting voltage, the faster the cutting speed, but the cutting quality may decrease. Therefore, it is necessary to adjust according to the actual situation to find the best cutting voltage.

5. Cutting speed:

Cutting speed refers to the distance that the molybdenum wire moves per unit time. The choice of cutting speed should be determined according to the type of material, thickness and cutting quality requirements. Generally speaking, too fast cutting speed will lead to reduced cutting quality, while too slow cutting speed will reduce production efficiency. Therefore, it is necessary to adjust according to the actual situation to find the best cutting speed.

6. Cutting distance:

Cutting distance refers to the distance between the molybdenum wire and the workpiece. The choice of cutting distance should be determined according to the type and thickness of the material. If the cutting distance is too large, the cutting quality will be reduced. If the cutting distance is too small, the friction between the molybdenum wire and the workpiece will increase and the cutting quality will be reduced. Therefore, it is necessary to adjust according to the actual situation to find the best cutting distance.

7. Test cutting quality:

After debugging, the cutting quality needs to be tested. You can select some standard workpieces for cutting, and then check the flatness, smoothness, and cutting defects of the cut surface. If the cutting quality does not meet the requirements, you can fine-tune the parameters according to the test results.

Zhikai's patented high-frequency technology, 6.5A high current, stable cutting speed of 9000-10000 square millimeters per hour, and low molybdenum wire loss; no need to use customized cutting fluid, saving use costs; new cool cutting control software, not picky about computers, can communicate with an Internet port, no driver installation required. For more knowledge, please consult Zhikai CNC: 180-1313-1588!